Problem with identd

Dani_Galera — Thu, 05 Jun 2008 08:17:58 GMT

hi

I just installed SG. I tried to check config with: "cmcheckconf -v -C $SGCONF/SAPCLUHPOS.config" and i recieve this error:

[root@emhbssap10 log]#cmcheckconf -v -C /usr/local/cmcluster/conf/SAPCLUHPOS.config
SAPCLUHPOS.config SAPCLUHPOS.config2
[root@emhbssap10 log]#cmcheckconf -v -C /usr/local/cmcluster/conf/SAPCLUHPOS.config
Begin cluster verification...
Checking cluster file: /usr/local/cmcluster/conf/SAPCLUHPOS.config
Checking nodes ... Done
Checking existing configuration ... Done
Gathering storage information
Unable to connect to node emhbssap10: Permission denied
Gathering network information
Beginning network probing (this may take a while)
Not probing node emhbssap10 as it is currently unreachable.
This may cause network partitions to be reported.
Completed network probing
cmcheckconf: Unable to reconcile configuration file /usr/local/cmcluster/conf/SAPCLUHPOS.config
with discovered configuration information.
[root@emhbssap10 log]#

The problem is identd because if i check the service:

root@emhbssap10 log]#service identd status
identd dead but pid file exists

the error that i have when i start process is:

Jun 6 10:15:23 emhbssap10 identd[7044]: fopen("/proc/net/tcp", "r"): Permission denied

so, permission process. I saw that in /etc/identd.conf the user startin the process is identd. so i changed to root and now i can start service but i receive this error when i try to check cluster:

[root@emhbssap10 ~]#cmapplyconf -k -v -C $SGCONF/SAPCLUHPOS.config
Begin cluster verification...
Checking cluster file: /usr/local/cmcluster/conf/SAPCLUHPOS.config
Checking nodes ... Done
Checking existing configuration ... Done
Gathering storage information
Gathering network information
Network interface bond0 cannot be found on node emhbssap10
Beginning network probing (this may take a while)
Completed network probing
Network interface bond0 on node emhbssap10 couldn't talk to itself.
Network interface eth0 on node emhbssap10 couldn't talk to itself.
cmapplyconf: Unable to reconcile configuration file /usr/local/cmcluster/conf/SAPCLUHPOS.config

any idea?

regards
Daniel

Re: Problem with identd

skt_skt — Thu, 05 Jun 2008 10:23:31 GMT

u dont need to change that to root. check if you have an entry in /etc/services.

auth 113/tcp authentication tap ident
auth 113/udp authentication tap ident

Make sure the port 113 is able to LISTEN. All the nodes need be checkded.

Could u put the ident entry from /etc/inetd.conf

Re: Problem with identd

Dani_Galera — Thu, 05 Jun 2008 11:44:24 GMT

hi

with root works and 113 is available. with user ident not working and port 113 KO. i think it's somthing with Jun 6 10:15:23 emhbssap10 identd[7044]: fopen("/proc/net/tcp", "r"): Permission denied

Regards

Re: Problem with identd

skt_skt — Fri, 06 Jun 2008 10:22:28 GMT

fopen i have seen when the sticky bit/set uid is missing!!

Re: Problem with identd

Dani_Galera — Fri, 06 Jun 2008 11:32:26 GMT

i resolved. NW problem, Once NW ok, all worked fine.

Regards

topic Re: Problem with identd in Operating System - Linux

Problem with identd

Re: Problem with identd

Re: Problem with identd

Re: Problem with identd

Re: Problem with identd