https://community.hpe.com/t5/operating-system-linux/modem-problem/m-p/3103300#M7481 PS. This is a multitech modem on the remote modem port of the mux pad. ioscan -fnC tty does show all the device files created by sam.<BR /><BR />Jun Mon, 27 Oct 2003 12:27:42 GMT Jun Zhang_4 2003-10-27T12:27:42Z https://community.hpe.com/t5/operating-system-linux/modem-problem/m-p/3103298#M7479 I added a modem within sam, got three device files, cu -l cua1p7, connected, ate1q0v1, no OK prompt. Did ~. the Disconnect line will stay there until I go to another session and kill the cu process. I then went back in sam, only see that the modem entry no longer there.<BR />Am I using a wrong cable or what, I never feel comfortable dealing with modems and terminals.<BR /><BR /><BR />Jun Mon, 27 Oct 2003 12:23:35 GMT https://community.hpe.com/t5/operating-system-linux/modem-problem/m-p/3103298#M7479 Jun Zhang_4 2003-10-27T12:23:35Z https://community.hpe.com/t5/operating-system-linux/modem-problem/m-p/3103299#M7480 You should post your question in the HP this is Linux <BR /><BR />J-P<BR /> Mon, 27 Oct 2003 12:27:22 GMT https://community.hpe.com/t5/operating-system-linux/modem-problem/m-p/3103299#M7480 Huc_1 2003-10-27T12:27:22Z https://community.hpe.com/t5/operating-system-linux/modem-problem/m-p/3103300#M7481 PS. This is a multitech modem on the remote modem port of the mux pad. ioscan -fnC tty does show all the device files created by sam.<BR /><BR />Jun Mon, 27 Oct 2003 12:27:42 GMT https://community.hpe.com/t5/operating-system-linux/modem-problem/m-p/3103300#M7481 Jun Zhang_4 2003-10-27T12:27:42Z