https://community.hpe.com/t5/operating-system-linux/cpqhealth-amp-smart-array-error-notification/m-p/2963862#M77121 Check Dmesg, also check to make sure kern.all is going somewhere in your /etc/syslog.conf Fri, 02 May 2003 12:42:29 GMT david_69 2003-05-02T12:42:29Z https://community.hpe.com/t5/operating-system-linux/cpqhealth-amp-smart-array-error-notification/m-p/2963861#M77120 I am running RH 8.0 on a DL380/G2 and have installed the Proliant Support Pack. The modules load and processes start. I don't have an Insight Manager stations. I would like to configure the system to log errors a log file. Right now, if I remove a disk from the RAID set, I see no messages anywhere. Thu, 01 May 2003 17:22:38 GMT https://community.hpe.com/t5/operating-system-linux/cpqhealth-amp-smart-array-error-notification/m-p/2963861#M77120 Jay McCanta 2003-05-01T17:22:38Z https://community.hpe.com/t5/operating-system-linux/cpqhealth-amp-smart-array-error-notification/m-p/2963862#M77121 Check Dmesg, also check to make sure kern.all is going somewhere in your /etc/syslog.conf Fri, 02 May 2003 12:42:29 GMT https://community.hpe.com/t5/operating-system-linux/cpqhealth-amp-smart-array-error-notification/m-p/2963862#M77121 david_69 2003-05-02T12:42:29Z