topic Machine Hangs after system is up in Operating System - Linux

Machine Hangs after system is up

Chakravarthi V S — Thu, 08 Feb 2001 10:15:29 GMT

Hi all,

I have a probelm in my Linux machine, the machine is loaded with redhat 6.2, it was intalled one week back, it was working fine, recently we had changed the ip address using ifconfig, it worked for one day, from yesterday onwards we are facing problems like, not responding, once the machine is up it'll work only for 10 min, then hangs, no responce at all.......

any idea about this problem

Re: Machine Hangs after system is up

ger donohue — Fri, 09 Feb 2001 09:46:13 GMT

boot into system as superuser by typing linux init=/sbin/init 1 when lilo prompt appears.
unmount all drives and fsck them.
have a look at /var/log/messages for clues
or any other log files as shown in /etc/syslog.conf

My gut feeling is a hardware problem.

do dmesg | more and look for any errors

Regards Ger

Re: Machine Hangs after system is up

Timmy_2 — Fri, 22 Jun 2001 13:12:48 GMT

Do you boot into X er not?
Because i had a couple of problems with linux redhat an the X-enviroment.

Re: Machine Hangs after system is up

Bill McNAMARA_1 — Fri, 22 Jun 2001 14:02:29 GMT

Why did you install 6.2?

In either case you can d/l linux on a floppy and mount your disk from that if you can't get lilo.
Then rescue with the linux rescue floppy.

Otherwise, if you can't get into init 1 or singleuser mode, init s then there is more than likely a h/w problem.

Do you see console at all?
Lilo even?
do you hear disk noises!

Later,
Bill