https://community.hpe.com/t5/operating-system-linux/linux-amp-mwa-ovpa/m-p/3131008#M8221 Take a look at the ovpa script and see where standard error output goes. You may wish to add this code to the script in the start section<BR /><BR />rc=$?<BR />if [ $rc -ne 0 ] then<BR /> echo "An error has been detected: $rc<BR />fi<BR /><BR />Then report the error, it will be meaningful.<BR /><BR />SEP Fri, 28 Nov 2003 09:32:06 GMT Steven E. Protter 2003-11-28T09:32:06Z https://community.hpe.com/t5/operating-system-linux/linux-amp-mwa-ovpa/m-p/3131007#M8220 Hi<BR /><BR />Trying to start the "mwa", executing ./ovpa start, the scopeux daemon is not running.<BR /><BR />./ovpa stop<BR />./ovpa start<BR /><BR />Still fail. All the daemons are running.<BR /><BR />Thanks for your help<BR /><BR /> Fri, 28 Nov 2003 06:34:42 GMT https://community.hpe.com/t5/operating-system-linux/linux-amp-mwa-ovpa/m-p/3131007#M8220 Harstad 2003-11-28T06:34:42Z https://community.hpe.com/t5/operating-system-linux/linux-amp-mwa-ovpa/m-p/3131008#M8221 Take a look at the ovpa script and see where standard error output goes. You may wish to add this code to the script in the start section<BR /><BR />rc=$?<BR />if [ $rc -ne 0 ] then<BR /> echo "An error has been detected: $rc<BR />fi<BR /><BR />Then report the error, it will be meaningful.<BR /><BR />SEP Fri, 28 Nov 2003 09:32:06 GMT https://community.hpe.com/t5/operating-system-linux/linux-amp-mwa-ovpa/m-p/3131008#M8221 Steven E. Protter 2003-11-28T09:32:06Z