topic Re: send mail configuration in Operating System - Linux

send mail configuration

Nick D'Angelo — Fri, 07 Sep 2001 14:22:58 GMT

I host a web site running Redhat 7.1 on an HP Kayak PC and act as their mail server. But I have one problem, sending mail.

I have configured my mail services so that the client, I'll call them farside, can remotely pick up their mail no problem.

The problem is if they want to send mail. Their email connection is refused at my end.

Can I set the farside up to send mail through my Redhat box as I am the mail server?

What happens if I get some additional remote clients that need mail also and they will probably be dynamic addresses?

Do I need to setup some sort of trust with that remote client?

I appreciate your help,

ND

Re: send mail configuration

Jeffrey S. Sims — Thu, 13 Sep 2001 15:01:25 GMT

I would think that you need to add them to your /etc/mail/access file, an entry such as:

name@domain.com RELAY

should do the trick. If they have a static ip or fall within a range and you want to open it up to that network address then you can add the ip to the /etc/mail/relay.allow file.

If you go with the /etc/amil/access file then the line:

Kaccess hash /etc/mail/access

should be in your sendmail.cf file. The /etc/mail/relay.allow is enabled by the line:

FR/etc/mail/relay.allow

in the sendmail.cf file. Either one of these methods should help you give the appropriate relay access.

Hope it helps.

Re: send mail configuration

Albert E. Whale, CISSP — Fri, 14 Sep 2001 15:18:47 GMT

Nick,

Just caught your Sendmail Issue, would be glad to help if you still need it.

In my configuration I make use of the /etc/aliases/relay-domains configuration file.

My configuration file is enabled vi the setting in the sendmail.cf (mine is in /etc/sendmail.cf), Look for something like the following in the config file.

# Hosts that will permit relaying ($=R)
FR-o /etc/mail/relay-domains

In this file, place the IP Address RELAY,
Domain Name RELAY

Or however you specify the name of the relaying systems, followed by a space and the work RELAY.

Hope that helps.

Re: send mail configuration

Stephen Suen — Fri, 21 Sep 2001 11:19:23 GMT

Nick,

If you wanna give support to your dynamic remote client for sending mail, there are two solutions for you: SMTP-After-POP3 and SMTP AUTH, and I suggest SMTP AUTH to you.

sendmail 8.10-8.12 support SMTP AUTH as defined in RFC 2554 which is based on SASL. Here are some resources for you:
http://www.sendmail.org/~ca/email/auth.html
http://www.asp.ogi.edu/people/paja/linux/sendmail/

Hope that helps.