https://community.hpe.com/t5/disk/setup-of-drive/m-p/2486485#M412 You can not configure a SCSI driver like it was IDE... Since the controller DOES see the full capacity (formatted is ALWAYS less than the rated capacity) it's not the drive's fault. Wed, 07 Feb 2001 00:00:00 GMT Ayman Altounji 2001-02-07T00:00:00Z https://community.hpe.com/t5/disk/setup-of-drive/m-p/2486484#M411 I brought the SCSI hard drive S/H 4.3GB DDRS-34560W. Upon trying to setup found that the drive only showed 1048MB but the adaptec AHA-2842VL controller showed 4094MB operating system windows 98. I would like to now the cylinders, heads, & sectors so I can set it up using ranish partition manager, but if anybody can help I would be most greatful. Thu, 25 Jan 2001 00:00:00 GMT https://community.hpe.com/t5/disk/setup-of-drive/m-p/2486484#M411 Ayman Altounji 2001-01-25T00:00:00Z https://community.hpe.com/t5/disk/setup-of-drive/m-p/2486485#M412 You can not configure a SCSI driver like it was IDE... Since the controller DOES see the full capacity (formatted is ALWAYS less than the rated capacity) it's not the drive's fault. Wed, 07 Feb 2001 00:00:00 GMT https://community.hpe.com/t5/disk/setup-of-drive/m-p/2486485#M412 Ayman Altounji 2001-02-07T00:00:00Z