https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140224#M4445 SC10 will be just a disk enclosure which has seperate disks. If it's connected with fc60 or Raid 4Si controller card, then you can create disk array LUNs on the disks. But if not, it can be treated as disks and you can manage it with either SAM or command line. Tue, 09 Dec 2003 14:50:15 GMT Helen French 2003-12-09T14:50:15Z https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140221#M4442 I am about to venture into supporting an N4000 with a SC10 disk storage attached. My question is, with the SC10, do you manage this using sam and normal command line commands? Or is there seperate software like the VA7100 to control the disks? Tue, 09 Dec 2003 14:39:54 GMT https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140221#M4442 Nobody's Hero 2003-12-09T14:39:54Z https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140222#M4443 Robert,<BR /><BR />Unless configured with the FC60 controller, an SC10 is JBOD: there are no utilities, no special commands, just plain old disk.<BR /><BR /><BR />Pete Tue, 09 Dec 2003 14:41:57 GMT https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140222#M4443 Pete Randall 2003-12-09T14:41:57Z https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140223#M4444 SC10 disk storage can be managed by normal unix commands and/or SA<BR /><BR />-USA.. Tue, 09 Dec 2003 14:45:50 GMT https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140223#M4444 Uday_S_Ankolekar 2003-12-09T14:45:50Z https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140224#M4445 SC10 will be just a disk enclosure which has seperate disks. If it's connected with fc60 or Raid 4Si controller card, then you can create disk array LUNs on the disks. But if not, it can be treated as disks and you can manage it with either SAM or command line. Tue, 09 Dec 2003 14:50:15 GMT https://community.hpe.com/t5/disk/surestore-sc10/m-p/3140224#M4445 Helen French 2003-12-09T14:50:15Z