topic Re: Drive Detection/malfunction in Disk

Drive Detection/malfunction

Tabassum — Wed, 23 Feb 2005 00:26:55 GMT

Hello,

I have Proliant ML150 with two SCSI Seagate(73 GB) Hard-disk on AIC-7902 Controller. They were woking fine till yesterday. In the morning, when people tried to access it, it was not available. on checking it was revealed that one of the hard disk was having problem.
The SCSISelect utility from Adaptec reports the following,

Unexpected SCSI Command failure
CBD sent: 25 00 00 00 00 00 00 00 00 00
Target Status: 02h Check condition
Sense key: 02h Not Ready
Sense Code: 04h
Sense Code Qualifier: 00h

Please tell me how i can recover the data from it. I have checked the HP site for the sense key information, it just tell me that 'Drive not ready...'.

any help would be greatlr appreciated.

Regards
Tabassum

Re: Drive Detection/malfunction

Peter Godron — Wed, 23 Feb 2005 07:22:08 GMT

Hi,
first check all the cabeling is secure and the chain is terminated ok.
Does the drive spin up i.e. is there power?
Regards

Re: Drive Detection/malfunction

Tabassum — Wed, 23 Feb 2005 07:40:24 GMT

well, I have placed that drive in another server, but the SCSISelet utility show the same error on another server too.

But when that machine boots up, it shows the faulty drive in the disk management utility. It displayed it as 'Missing' and when choose to reactivate it, it says 'windows cannot locate specified disk'.

How can i check that drive is spinning. the adaptec do not have any utility that test the spinning.

I do not want to opt for the low-level format, as the data is really very important.

an early help will be greatly appreciated!!

Best Regards,
Tabassum

Re: Drive Detection/malfunction

Peter Godron — Wed, 23 Feb 2005 08:00:35 GMT

Hi,
I am a bit confused, the disk was seen when you mounted it into the second server, yet it could not be activated.
This either means the disk is not mountable i.e. faulty platter or no power on the disk,but the SCSI bus is still working.
Start the machine up and look for a LED on the drive to show powerup.Alternatively listen for the whine when the disk spins up.
This would then say power is ok, but disk media is not :-(
Regards

Re: Drive Detection/malfunction

Tabassum — Wed, 23 Feb 2005 08:12:43 GMT

Yes, it can be seen but not activated!!!

Power LED was on for the faulty drive. When machine boots up, all other disk spins-up and the status LED blinks but for the faulty drive, the second LED do not blink. it remains OFF.

Regards,
Tabassum

Re: Drive Detection/malfunction

Peter Godron — Wed, 23 Feb 2005 09:29:00 GMT

Tabassum,
based on what you have written and the steps we tried I would think your disk is broken.
The SCSI chain is working and the the disk can be seen, power is on the board, but the disk does not spin up.You have tried it on another machine/controller, so its the disk that's at fault.

Unless somebody else has a better analysis, you will have to replace the drive and restore the backup.
Regards

Re: Drive Detection/malfunction

Tabassum — Wed, 23 Feb 2005 23:12:04 GMT

Okay, I think you are right....
but it becomes a disaster for me. Can you kindly suggest any data recovery company that can recover data from it and how much is the chance of getting data from it.

Regards,
Tabassum

Re: Drive Detection/malfunction

ephraim_2 — Thu, 24 Feb 2005 07:11:19 GMT

HI Tabassum

I AM TECH MANAGER AT OUR COMPANY.
WWW.DISK-O-TECH.COM
WE ARE IN ISRAEL

WE MIGHT HEKP YOU

BRGDS
EPHRAI FRIEDMAN

Re: Drive Detection/malfunction

Tabassum — Thu, 24 Feb 2005 07:16:45 GMT

thanks!! but looking for some office in Asia.

Regards,
Tabassum

Re: Drive Detection/malfunction

ephraim_2 — Thu, 24 Feb 2005 07:32:26 GMT

ACTUALLY WE ARE IN ASIA

WE ARE EXPERT WITH DATA RECOVERY

DON'T PLAY WITH THE DISK

EPHRAIM FRIEDMAN
WWW.DISK-O-TECH.COM

Re: Drive Detection/malfunction

Tabassum — Thu, 24 Feb 2005 07:37:41 GMT

Thanks for your offer.

But I want a quick repair/recovery solution, that is why I am looking for some office in Singapore/Dubai/Australia.

Can anyone please suggest/recommend about good data recovery companies.... what about datasaver.

Thanks in advance

Regards,
Tabassum

Re: Drive Detection/malfunction

Marino Meloni_1 — Sat, 26 Feb 2005 11:37:26 GMT

You can try this:
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=lpg70004
if you are HP customer you can get a discount

http://www.vogon-international.com/disk/disk-recovery.htm