topic va7410 warning state in Disk Enclosures

va7410 warning state

vladimir_1 — Mon, 05 Jan 2004 06:45:11 GMT

The VA's amber LED are on on controller enclosure as well as on disk enclosure and one of drives itself(JB1/D11). There is a string about media error on that drive in armlog dated three days ago, BUT armdsp shows this drive as ready. Just there is a warning:

...one or more drives has only a single path of access to it.

Questions: should I exchange the drive? Why armlog shows it as good/ready? How failure of a drive leads to losing of second path? Why SDM does not show warning state of the VA?

Re: va7410 warning state

Rajesh G. Ghone — Mon, 05 Jan 2004 07:57:39 GMT

Hi,

I have faced same problem.
Below are the steps to resolve this issue.

1) Upgrade Command View SDM to 1.07
2) Upgrade VA Controller to A120 at present it is A000 which is very old that also can give u problem.
3) Upgrade Disk Firmware to HP09 at present it is HP08.

If this doesnt solves ur problem then post ur armdiag output or logprn output to study more about this VA.

Regards,
Rajesh G.

Re: va7410 warning state

Rajesh G. Ghone — Mon, 05 Jan 2004 08:04:40 GMT

Hi,

Your C1 & C2 Host Port2 is of 1Gb where as Host Port1 is 2Gb why is this so??

& ur C1/H2 & C2/H2 Link is Down

can u check FC cables weather the link is proper or not??

This could create a problem.

& upgrade DS2405 Firmware to HP04.

Regards,
Rajesh G.

Re: va7410 warning state

vladimir_1 — Mon, 05 Jan 2004 08:27:02 GMT

Thanks, Rajesh,

Port 2 are not connected to HBAs so their link is down.

The question remains: should I exchange the drive that logged media error and now has amber LED on?

Re: va7410 warning state

Dave Thomson — Tue, 06 Jan 2004 04:00:20 GMT

Hello....

The drive probably disconnected and reconnected its self. Have you heard of the famous VA7400 has connection problems issue. Well you probably have it.

You can either have the drive replaced, but i doubt HP will do this. Remove the drive. Check if the VA starts a rebuild. If so do not plug in the drive till it is finished the rebuild. Plug in the drive after rebuild.
Watch the status and make sure rebuild completes again.

Hope this helps

Re: va7410 warning state

Rajesh G. Ghone — Mon, 08 Mar 2004 12:06:40 GMT

Yaa u please replace that drive which is showing amber LED on.

Regards,
Rajesh G.