topic Re: Primary/alternate links, VA7400 and LVM in Disk Enclosures

Primary/alternate links, VA7400 and LVM

Murat SULUHAN — Thu, 18 Mar 2004 09:21:14 GMT

Hi

I am using VA7400 with 2 HP-UX servers and 2 Brocade. My question is about LUNs and primary/alternate links for VGs.

I successfully created a LUN in redundancy group 1 and when I want to create a new VG or extend previously created VG on the disk-array with this LUN, how can I determine which device is primary link and which is secondary link

Best Regards
Murat

Re: Primary/alternate links, VA7400 and LVM

Bernhard Mueller — Thu, 18 Mar 2004 09:57:40 GMT

Murat
vgdisplay -v will tell you

if you need to reverse:
vgreduce
vgextend

(LVM automatically makes the alternate link the primary after the vgreduce, so vgextend with the same device will make that device the alternate link)

Regards,
Bernhard

Re: Primary/alternate links, VA7400 and LVM

Murat SULUHAN — Thu, 18 Mar 2004 10:54:40 GMT

Hi Bernhard

I already know this command, but HP configured our initial VGs,

I attached a file about ioscan -funC disk and vgdisplay -v outputs from same host.

For example vg01 has 4 LUN and first 2 LUN's primary link different from others. I cannot figured out. and vg02 also has 4 LUN and all of them has belong to same primary link.

So I want to learn how to configure array but I don't understand primary links and LUNs with these situation

Thanks for your response,

Best Regards
Murat

Re: Primary/alternate links, VA7400 and LVM

Jim Viera — Thu, 18 Mar 2004 17:33:57 GMT

Murat,

I assume that you have 2 separate SAN fAbrics. The host hba that's attached to the fabric with controller 1 of your VA7400 should be your primary path for the LUNs you create in redundancy group 1. The opposite is true for the LUNs you create in redundancy group 2.

We have 2 SAN fabrics with two VA7400's but we are NOT using the same Domain ID's on both fabrics.

You will need to match your host hba's with the VA7400 hba's and assign primary and secondary accordingly.

Regards,
Jim

Re: Primary/alternate links, VA7400 and LVM

Bernhard Mueller — Mon, 22 Mar 2004 08:18:09 GMT

Murat,

LVM uses the alternate link for data transfer only if the primary link fails.

You have two HBAs and so for each LUN you have two path.

In order to setup a static load balancing using *both* paths you would usually alternate the primary link either for each LUN or with each VG

This has not been done consistently. If I were you I would use vgreduce/vgextend and make the /dev/dsk/c5 device files the primary link for all even LUNs (d0, d2, d4, d6) and the /dev/dsk/c7 device files the primary link for all odd LUNs (d1, d3, d5, d7).

As long as ioscan -fnCdisk shows all devices claimed you can do this without risk and on the fly.

Regards,
Bernhard