https://community.hpe.com/t5/disk-enclosures/model-10-storage-array-won-t-start-up-into-grid-manager/m-p/3271453#M12063 I have acquired a used Nike Model 10 storage array with 10 2-gb disks installed and 2 SPs. Upon hooking up a vt100 terminal directly to SP-A console port and then powering it up (without attaching to host), I get a banner meesage followed by printing of the alphabet up to the letter 'T' then get a 'System Storage Failure, Information Code 0001007f'. I have found in an internet document that this may have something to do with internal licensing and would need to get a properly preparted disk in slot 'A0'. My problem is that after placing each of my 10 disks in A0 and repowering the array, I get the same failure messge each time. Also, all service lights show okay. Any ideas?<BR /><BR />Thank you,<BR /><BR />David Sun, 09 May 2004 23:17:05 GMT David Sherrill_1 2004-05-09T23:17:05Z https://community.hpe.com/t5/disk-enclosures/model-10-storage-array-won-t-start-up-into-grid-manager/m-p/3271453#M12063 I have acquired a used Nike Model 10 storage array with 10 2-gb disks installed and 2 SPs. Upon hooking up a vt100 terminal directly to SP-A console port and then powering it up (without attaching to host), I get a banner meesage followed by printing of the alphabet up to the letter 'T' then get a 'System Storage Failure, Information Code 0001007f'. I have found in an internet document that this may have something to do with internal licensing and would need to get a properly preparted disk in slot 'A0'. My problem is that after placing each of my 10 disks in A0 and repowering the array, I get the same failure messge each time. Also, all service lights show okay. Any ideas?<BR /><BR />Thank you,<BR /><BR />David Sun, 09 May 2004 23:17:05 GMT https://community.hpe.com/t5/disk-enclosures/model-10-storage-array-won-t-start-up-into-grid-manager/m-p/3271453#M12063 David Sherrill_1 2004-05-09T23:17:05Z