3200 array controller on proliant ml350 and warning message

Oskar Teran — Sat, 17 Jul 2004 14:11:05 GMT

hello,
I'm trying to install SCO 5.0.5 on proliant ML350 with a 3200 array controller.
I found the SCO document specifying to use the BTLD disks to load the driver for the 3200 array controller. I follow those steps, but after the driver loads successfully, I see a warning:

Test open failed "hd=Sdsk", no root disk controller.
System configuration has not been run on this controller, use system configuration to assign order of this controller.

I have the smartstart 5.5 disk and I've used it to prepare the server. I don't see any tools on it to run the system configuration. I've installed Proliant 800/1600's and they have the system config. available when you press F10 during bootup. I press F10 on this server and I don't get a menu where system config. is available.
So....how can I get past this hurdle?

Thanks,

Oskar

Re: 3200 array controller on proliant ml350 and warning message

Oskar Teran — Sat, 17 Jul 2004 16:18:04 GMT

he complete warning message is as follows:
Warning: ida: the order of the controller in slot 6 is unassigned - using ida0

Then follows the message saying system config. has not been run.

I've tried messing around with the bootstrings but still no luck...

topic Re: 3200 array controller on proliant ml350 and warning message in Disk Enclosures

3200 array controller on proliant ml350 and warning message

Re: 3200 array controller on proliant ml350 and warning message