topic Re: Windows 2000 Server Setup Hang in Disk Enclosures

Windows 2000 Server Setup Hang

Jian_2 — Sun, 02 Jan 2005 01:06:51 GMT

Hi,

Our Server is a Compaq ML530 P19 800/128 Mhz, 1GB RAM, with Smart array 3200 with an existing NT4 OS. 4x18GB HD, RAID5 with online spare.

Whenever I boot the win2k installer cd, the setup hangs after loading all the drivers. The screen that is supposed to ask to Press Enter to Continue, R for repair and F3 to quit does not appear. All lights of the HD are on as if it is reading.

I have already updated the BIOS and Firmware of the scsi controller but thesame problem.

What are the possible reasons why Win2K setup hangs?

I have another Identical server (twin server, all hardware settings are thesame but with Netware 5 OS) and the win2k setup runs fine on that machine.

Could this be a controller problem?

If I swap the controllers of the two servers, will it have any effect on the data of both the servers?

jian

Re: Windows 2000 Server Setup Hang

Marino Meloni_1 — Sun, 02 Jan 2005 17:06:21 GMT

there is an utility in the smartstart cd that is used to clear all the config of the server, this utility will clear ramcmos and reset all the resources in the server (irq, mem allocations...)
then, be sure to select W2K in the bios setup before to install the OS, because w2k is P&P and NT4 was not.

marino

Re: Windows 2000 Server Setup Hang

Jian_2 — Mon, 03 Jan 2005 00:52:19 GMT

This procedure should not erase our data in the HD right??

Re: Windows 2000 Server Setup Hang

Marino Meloni_1 — Mon, 03 Jan 2005 02:39:36 GMT

yes it will clear all

Re: Windows 2000 Server Setup Hang

Marino Meloni_1 — Mon, 03 Jan 2005 02:46:12 GMT

I mean: the utility will clear all config data and will inizialize Hdd, so your data will be not accessible anymore

Re: Windows 2000 Server Setup Hang

Jian_2 — Mon, 03 Jan 2005 05:41:12 GMT

No, I want to preserve all data...

Re: Windows 2000 Server Setup Hang

Vincent Fleming — Mon, 03 Jan 2005 07:36:41 GMT

If I'm reading your post correctly, you're trying to upgrade an NT4 machine to Win2k.

Does it still boot into NT4?

If so, you could backup the data, then reset the config, install the OS, and restore the data.

Also, if I remember my Win2k upgrade procedures, you should be able to perform the upgrade by booting NT4, insert the install CD, and upgrade from there (ie: usermode, rather than bootmode).

Good luck,

Vince

Re: Windows 2000 Server Setup Hang

Jian_2 — Mon, 03 Jan 2005 09:33:58 GMT

Swapping the SCSI Controllers had thesame result(hang up). But after swapping the HDs, then everything went fine. I guess it has something to do with the CMOS setup (main board).

I just finished installing Win2K with all my data in Drive D.

Thanks all for the reply/suggestions.