https://community.hpe.com/t5/disk-enclosures/easy-one-netraid-4m-using-fast-on-hp2300-disk-system/m-p/3549031#M16235 Hi Jeff,<BR /><BR />What will happen is ID 9 (the new drive that you are going to put in inplcae of the failed one) will be available to be configured as a hotspare or as a member of a new container. <BR /><BR />Once the rebuild is done on ID 14 it is not going to try to rebuild to ID 9 when you put a new drive in ID 9.<BR /><BR />You can configure ID 9 as a hotspare<BR /><BR /><BR />Regards<BR />Amha Kassa Mon, 23 May 2005 05:12:37 GMT amhakassa 2005-05-23T05:12:37Z https://community.hpe.com/t5/disk-enclosures/easy-one-netraid-4m-using-fast-on-hp2300-disk-system/m-p/3549030#M16234 We had a failed drive on our HP2300 Disk System (Drive ID:09)which is controlled by a NetRaid-4M controller and it started a rebuild to the spare that we have configured(Drive ID:14). What I would like to know is when I reinsert the Drive ID:09 with a new drive will it try and start a rebuild on it too? If so how do I stop it from doing that because I would like to make ID:09 a spare as ID:14 is now part of the container.<BR />Thanks,<BR />Jeff Fri, 20 May 2005 14:31:11 GMT https://community.hpe.com/t5/disk-enclosures/easy-one-netraid-4m-using-fast-on-hp2300-disk-system/m-p/3549030#M16234 Jeff Kauk 2005-05-20T14:31:11Z https://community.hpe.com/t5/disk-enclosures/easy-one-netraid-4m-using-fast-on-hp2300-disk-system/m-p/3549031#M16235 Hi Jeff,<BR /><BR />What will happen is ID 9 (the new drive that you are going to put in inplcae of the failed one) will be available to be configured as a hotspare or as a member of a new container. <BR /><BR />Once the rebuild is done on ID 14 it is not going to try to rebuild to ID 9 when you put a new drive in ID 9.<BR /><BR />You can configure ID 9 as a hotspare<BR /><BR /><BR />Regards<BR />Amha Kassa Mon, 23 May 2005 05:12:37 GMT https://community.hpe.com/t5/disk-enclosures/easy-one-netraid-4m-using-fast-on-hp2300-disk-system/m-p/3549031#M16235 amhakassa 2005-05-23T05:12:37Z