https://community.hpe.com/t5/disk-enclosures/commandviewsdm-launcher-status/m-p/3580379#M16780 Hello,<BR /><BR />I ran `cvui'. I could get not anything, except `Refresh'. But why I don't see Launcher screen properly. It used to be.<BR /><BR />Regards,<BR />Samir Sun, 17 Jul 2005 04:01:41 GMT SAMIR DANDEKAR 2005-07-17T04:01:41Z https://community.hpe.com/t5/disk-enclosures/commandviewsdm-launcher-status/m-p/3580377#M16778 Hello,<BR /><BR />I have VA7110 with Commandview SDM 1.07 installed on HPUX 11i. Last couple of days I see `Status:????' in `Launcher' GUI.<BR /><BR />Has anybody experienced this problem?<BR /><BR />Regards,<BR />Samir Tue, 12 Jul 2005 06:27:56 GMT https://community.hpe.com/t5/disk-enclosures/commandviewsdm-launcher-status/m-p/3580377#M16778 SAMIR DANDEKAR 2005-07-12T06:27:56Z https://community.hpe.com/t5/disk-enclosures/commandviewsdm-launcher-status/m-p/3580378#M16779 May be there is a problem in communicating to VA. Try the command line utility cvui located under /opt/sammgr/commandview/client/sbin<BR /><BR />I always use commands to monitor the array.<BR /><BR />Regds<BR />TT<BR />armdiscover<BR />armdsp<BR />armlog<BR />and many more commands also available here.<BR /> Tue, 12 Jul 2005 08:42:48 GMT https://community.hpe.com/t5/disk-enclosures/commandviewsdm-launcher-status/m-p/3580378#M16779 Thayanidhi 2005-07-12T08:42:48Z https://community.hpe.com/t5/disk-enclosures/commandviewsdm-launcher-status/m-p/3580379#M16780 Hello,<BR /><BR />I ran `cvui'. I could get not anything, except `Refresh'. But why I don't see Launcher screen properly. It used to be.<BR /><BR />Regards,<BR />Samir Sun, 17 Jul 2005 04:01:41 GMT https://community.hpe.com/t5/disk-enclosures/commandviewsdm-launcher-status/m-p/3580379#M16780 SAMIR DANDEKAR 2005-07-17T04:01:41Z