https://community.hpe.com/t5/disk-enclosures/failed-disk-in-ra-3000/m-p/3603211#M17217 <BR />Can you provide array configuration details here ? Tue, 16 Aug 2005 18:42:32 GMT Sameer_Nirmal 2005-08-16T18:42:32Z https://community.hpe.com/t5/disk-enclosures/failed-disk-in-ra-3000/m-p/3603210#M17216 hello all,<BR />I have a failed disk in RA 3000. It consists of two units (one is expansion unit). There are two virtual disks configured, U00 and U01, the failed disk is in U00 (in the expansion unit) and its state is reduced as the controller has not failed over the failed disk's data to the spare disk. But the problem is that in SWCC I can see U01 also in reduced state where as in its properties all its member disks are shown in good condition. Neither do I see the amber LED on any of its disk. What can be the reason for this? Also I am going to change the failed HDD soon so will it be affected in any way? Sat, 13 Aug 2005 07:04:41 GMT https://community.hpe.com/t5/disk-enclosures/failed-disk-in-ra-3000/m-p/3603210#M17216 shashang 2005-08-13T07:04:41Z https://community.hpe.com/t5/disk-enclosures/failed-disk-in-ra-3000/m-p/3603211#M17217 <BR />Can you provide array configuration details here ? Tue, 16 Aug 2005 18:42:32 GMT https://community.hpe.com/t5/disk-enclosures/failed-disk-in-ra-3000/m-p/3603211#M17217 Sameer_Nirmal 2005-08-16T18:42:32Z