topic 5300 Array Controller gets error and won't boot in Disk Enclosures https://community.hpe.com/t5/disk-enclosures/5300-array-controller-gets-error-and-won-t-boot/m-p/3627945#M17680 I have a 5300 controller (in an ML530) and it comes up with the following error when it tries to boot:<BR /> "1783- Slot 7 Drive Array Controller Failure! [Command failure (cmd=0h, err=00h, dlu=0f013:167fh)]"<BR /><BR />I tried the obvious- replaced the controller- to no avail. <BR /><BR />If I play around with it enough I can get it to boot. Insight Manager tells me the "Array Accelerator is disabled" and the server was coming up with "1798-Slot 7 Drive Array- Array Accelerator is not enabled" earlier today.<BR /><BR />Problem seemed to occur when I installed the driver from the 7.30 Support Pack (5.60.0.32). I tried going back to old version, but that did not work. I even tried the newest driver released Sept 9 same thing. <BR /><BR />I've tried going into the System Config Utility, but that didn't do anything. <BR />Could the array accelerator be bad or causing my problem? If so, can I fix it without totally rebuilding my server?<BR /><BR />Thanks in advance! Fri, 16 Sep 2005 10:50:06 GMT Allen Largent 2005-09-16T10:50:06Z 5300 Array Controller gets error and won't boot https://community.hpe.com/t5/disk-enclosures/5300-array-controller-gets-error-and-won-t-boot/m-p/3627945#M17680 I have a 5300 controller (in an ML530) and it comes up with the following error when it tries to boot:<BR /> "1783- Slot 7 Drive Array Controller Failure! [Command failure (cmd=0h, err=00h, dlu=0f013:167fh)]"<BR /><BR />I tried the obvious- replaced the controller- to no avail. <BR /><BR />If I play around with it enough I can get it to boot. Insight Manager tells me the "Array Accelerator is disabled" and the server was coming up with "1798-Slot 7 Drive Array- Array Accelerator is not enabled" earlier today.<BR /><BR />Problem seemed to occur when I installed the driver from the 7.30 Support Pack (5.60.0.32). I tried going back to old version, but that did not work. I even tried the newest driver released Sept 9 same thing. <BR /><BR />I've tried going into the System Config Utility, but that didn't do anything. <BR />Could the array accelerator be bad or causing my problem? If so, can I fix it without totally rebuilding my server?<BR /><BR />Thanks in advance! Fri, 16 Sep 2005 10:50:06 GMT https://community.hpe.com/t5/disk-enclosures/5300-array-controller-gets-error-and-won-t-boot/m-p/3627945#M17680 Allen Largent 2005-09-16T10:50:06Z