https://community.hpe.com/t5/disk-enclosures/installation-question/m-p/2525366#M1832 1) Run SmartStart <BR />2) Create the 4 NT install diskettes <BR />3) If booting from NT4 cd start hitting F6 when cd starts to boot, under win2k hit F6 when you seee the prompt. <BR />4) At the next window, select S to specify mass storage device. <BR />5) At the next window, select Other <BR />6) Insert SSD diskette with scsi subdirectory ; (disk 2 currently) <BR />7) Select "Compaq Integrated Smart Array\42xx Controllers" <BR />8) At the next window, select S to specify more mass storage devices <BR />9) At the next window, hit the UP arrow and select IDE CD-ROM <BR />10) Continue hitting S to specify mass storage devices until all scsi and array drivers are recognized <BR />11) Proceed with rest of NT installation Sun, 06 May 2001 23:00:01 GMT Ayman Altounji 2001-05-06T23:00:01Z https://community.hpe.com/t5/disk-enclosures/installation-question/m-p/2525365#M1831 I've installed a 431 in a Compaq 370, and seem to have a problem getting NT to recognize it. This will be the boot drive, so I tried F6'ing during the installation, but the floppy disk only shows 4 types of drives....If I let the installation continue, and try to install by the book, I get the 431 controller option off the same floppy, but it can't detect any drives to install NT. Any help? Sun, 06 May 2001 23:00:00 GMT https://community.hpe.com/t5/disk-enclosures/installation-question/m-p/2525365#M1831 Ayman Altounji 2001-05-06T23:00:00Z https://community.hpe.com/t5/disk-enclosures/installation-question/m-p/2525366#M1832 1) Run SmartStart <BR />2) Create the 4 NT install diskettes <BR />3) If booting from NT4 cd start hitting F6 when cd starts to boot, under win2k hit F6 when you seee the prompt. <BR />4) At the next window, select S to specify mass storage device. <BR />5) At the next window, select Other <BR />6) Insert SSD diskette with scsi subdirectory ; (disk 2 currently) <BR />7) Select "Compaq Integrated Smart Array\42xx Controllers" <BR />8) At the next window, select S to specify more mass storage devices <BR />9) At the next window, hit the UP arrow and select IDE CD-ROM <BR />10) Continue hitting S to specify mass storage devices until all scsi and array drivers are recognized <BR />11) Proceed with rest of NT installation Sun, 06 May 2001 23:00:01 GMT https://community.hpe.com/t5/disk-enclosures/installation-question/m-p/2525366#M1832 Ayman Altounji 2001-05-06T23:00:01Z