https://community.hpe.com/t5/disk-enclosures/bad-battery/m-p/2525370#M1836 During bootup, the Smart Array 4200 reports the following error: <BR />Array Accelerator is temporarily disabled. <BR />Array Accelerator will be reenabled when battery reaches full charge. <BR /> <BR />The first time this happened, it didn't worry me. However, this is a new server (DL580) and a new array (rev A ver 1.01)and this is the third time that this has happened. The first two times, the battery seemed to be "recharged" after about 3 hours. It's been 5 hours now and I'm getting the same error. How can I check the integrity of the battery? Sun, 06 May 2001 23:00:00 GMT Ayman Altounji 2001-05-06T23:00:00Z https://community.hpe.com/t5/disk-enclosures/bad-battery/m-p/2525370#M1836 During bootup, the Smart Array 4200 reports the following error: <BR />Array Accelerator is temporarily disabled. <BR />Array Accelerator will be reenabled when battery reaches full charge. <BR /> <BR />The first time this happened, it didn't worry me. However, this is a new server (DL580) and a new array (rev A ver 1.01)and this is the third time that this has happened. The first two times, the battery seemed to be "recharged" after about 3 hours. It's been 5 hours now and I'm getting the same error. How can I check the integrity of the battery? Sun, 06 May 2001 23:00:00 GMT https://community.hpe.com/t5/disk-enclosures/bad-battery/m-p/2525370#M1836 Ayman Altounji 2001-05-06T23:00:00Z https://community.hpe.com/t5/disk-enclosures/bad-battery/m-p/2525371#M1837 the battery may take as long as 24 hours now more than 48 I would say to recharge if this does not happen then the controller will most likely need to be replaced. Sun, 06 May 2001 23:00:01 GMT https://community.hpe.com/t5/disk-enclosures/bad-battery/m-p/2525371#M1837 Ayman Altounji 2001-05-06T23:00:01Z