HSG80 Replacement battery procedure

meekrob — Sat, 26 Nov 2005 05:40:03 GMT

Hi

Plesae i nedd to replace the ECB battery ( ON LINE ) for HSG80, so can some one help me

Thanks

Re: HSG80 Replacement battery procedure

Emad Omar — Sun, 27 Nov 2005 00:37:49 GMT

Hi Rue,

Find below the easy steps to replace the ECB Battery of HSG80 online:

1.Connect a PC or terminal to the maintenance port of the controller that has the defective ECB. The controller connected to the PC or terminal becomes â this controller.â

2.For Model 2100 and 2200 enclosures, enter the following command to verify that system time is set:
SHOW THIS_CONTROLLER FULL

3.If system time is not set or current, enter current data using the following command:
SET THIS_CONTROLLER TIME=dd-mmm-yyyy:hh:mm:ss

4.Start FRUTIL with the following command: RUN FRUTIL

5.Follow on-screen instructions concerning availability and replacement questions for the ECB.

6.Insert the replacement ECB into an appropriate bay or near the ECB being removed.

7.Follow on-screen instructions to connect the ECB.

8.Disconnect the ECB Y-cable from the old ECB and press Enter/Return.
IMPORTANT: Wait for FRUTIL to terminate.

9.For single ECB replacement:
a. Remove the old ECB and place the ECB in an antistatic bag or on a grounded antistatic mat.
b. If the replacement ECB was not placed within an available bay, install the ECB into the vacant bay of the old ECB.

10.For dual ECB replacement:
c. If the other cache module is also to be connected to the new dual ECB, connect the PC or terminal to the â other controllerâ maintenance port.
d. The connected controller now becomes â this controller.â
e. Repeat step 6 through step 10.

Hope this help.

Kind regards,

Emad Omar

Re: HSG80 Replacement battery procedure

Larry De Clay — Sun, 27 Nov 2005 15:21:27 GMT

Rue,
You have to use the FRUTIL command. May be you have to set the date/time in the storage.
And you have to follow the instructions that the FRUTIL shows.
In the ESA/RA you have to use the Y cable to connect the new battery but in the MA you have to put the battery in the slot.

Good luck,
Larry

topic HSG80 Replacement battery procedure in Disk Enclosures

HSG80 Replacement battery procedure

Re: HSG80 Replacement battery procedure

Re: HSG80 Replacement battery procedure