https://community.hpe.com/t5/disk-enclosures/new-controller-no-netware-partitions-seen/m-p/2535328#M1992 I have to do the same operation but I don't understand why you didn't extend the logical drive instead of create a new one. Wouldn't it be easier ? Thu, 20 Sep 2001 23:00:00 GMT Ayman Altounji 2001-09-20T23:00:00Z https://community.hpe.com/t5/disk-enclosures/new-controller-no-netware-partitions-seen/m-p/2535327#M1991 Hi All <BR /> <BR />Proliant 1600 <BR />Bios uptodate. <BR />Netware 4.11 and SP9a <BR /> <BR />Have a Proliant 1600 with 5 x 9GB and a 2SL controller <BR />Need to install another 9GB drive. <BR /> <BR />Installed 3200 controller with the new drive. <BR />Expanded the array and created a new logical drive. <BR /> <BR />Restarted server. <BR />Two logical drives found message on boot up. <BR />Loaded Netware but no volumes seen. Loaded installed and no netware partitions available. As you can see the rebuild of the raid was successful otherwise I wouldn't see C:\ and load partial NetWare. <BR /> <BR />Installed back the old 2SL card and server booted normally. Ran install, created netware partiton on second logical drive and added this space to exisitng volumes. <BR /> <BR />Anyone know why I cant see the netware partitons with the new controller? <BR /> <BR />Maybe I should have flashed the 3200 with the latest firmware, although in the heat of the moment I needed it up fast. <BR /> <BR />Dave Thu, 31 May 2001 23:00:00 GMT https://community.hpe.com/t5/disk-enclosures/new-controller-no-netware-partitions-seen/m-p/2535327#M1991 Ayman Altounji 2001-05-31T23:00:00Z https://community.hpe.com/t5/disk-enclosures/new-controller-no-netware-partitions-seen/m-p/2535328#M1992 I have to do the same operation but I don't understand why you didn't extend the logical drive instead of create a new one. Wouldn't it be easier ? Thu, 20 Sep 2001 23:00:00 GMT https://community.hpe.com/t5/disk-enclosures/new-controller-no-netware-partitions-seen/m-p/2535328#M1992 Ayman Altounji 2001-09-20T23:00:00Z