topic MSA1000 in Disk Enclosures

MSA1000

meekrob — Tue, 03 Oct 2006 17:24:32 GMT

Hi ,
I have installed an MSA1000 and connect it to an rp7XXX HP-UX 11.23 server ,
i have these questions:
- when i put show connection in the CLI of the MSA1000 it gives me no such command ??
- did i have to create LUN first the i can show the MSA1000 by the ioscan
- note that i connect directly the MSA1000 to the server (fiber connection) , is there any parameter i have to change on the MSA1000 so it could be seen by the server

thank you

Re: MSA1000

Jefferson Humber — Tue, 03 Oct 2006 17:50:09 GMT

Hi,

You can't shorten the MSA CLI commands, so what you need to use is;

SHOW CONNECTIONS

The 's' on the end makes all the difference.

Can't help you with the HP-UX bits though, never used it.

Hope this helps,

Jeff

Re: MSA1000

Sandy Chen — Sun, 08 Oct 2006 23:41:27 GMT

Hi,

- Refer to these documents for CLI guide:
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00683579/c00683579.pdf

- You must create the LUN first, and then create the connections to the server

- For HPUX, you can can add the profile name while you are adding connection. But it is not mandatory, your server will still be able to see the disk even if it using default value

regards,
Sandy