https://community.hpe.com/t5/disk-enclosures/smart-array-problem/m-p/4074663#M24941 Hi,<BR /><BR />I've got a few problems with a HP Smart Array 5302/32 Controller. <BR /><BR />When I boot my server, I don't get "press F8 to configure array" prompt. And the machine won't boot. <BR /><BR />It stops at this message:<BR />"1729-Slot 1 Drive Array - Performance Optimization Scan In Progress RAID 4/5/ADG performance may be higher after completion."<BR /><BR />But earlier there was another message that i couldn't bypass. So it stops whenever there is a message. It doesn't say that I should press any specific button either. I've tried pressing ENTER and so on..<BR /><BR />I can't press anything to bypass this. The only way for me to boot my machine, is to pull out all SCSI-disks from SCSI-Enclosure connected to the HP Smart Array 5302/32 Controller and boot from the internal SCSI-RAID controller. The afterwards, put the SCSI-disks back in the SCSI-Enclosure and use the CLI to configure the RAID-config. <BR /><BR />Does anyone know what to do? I've upgraded the firmware. I use a Compaq StorageWorks 4354R Enclosure.<BR /><BR />Another question, I can't get the array configuration utility (ACU) to work, thats why i have to use the CLI. Internet explorer says it can't find the page, and ask me to check that I'm connected to the internet. I've tried both local and remote. I use Windows 2006 x64 SP2.<BR /><BR />Sorry if my english is poor... Sun, 23 Sep 2007 20:34:56 GMT altgard 2007-09-23T20:34:56Z https://community.hpe.com/t5/disk-enclosures/smart-array-problem/m-p/4074663#M24941 Hi,<BR /><BR />I've got a few problems with a HP Smart Array 5302/32 Controller. <BR /><BR />When I boot my server, I don't get "press F8 to configure array" prompt. And the machine won't boot. <BR /><BR />It stops at this message:<BR />"1729-Slot 1 Drive Array - Performance Optimization Scan In Progress RAID 4/5/ADG performance may be higher after completion."<BR /><BR />But earlier there was another message that i couldn't bypass. So it stops whenever there is a message. It doesn't say that I should press any specific button either. I've tried pressing ENTER and so on..<BR /><BR />I can't press anything to bypass this. The only way for me to boot my machine, is to pull out all SCSI-disks from SCSI-Enclosure connected to the HP Smart Array 5302/32 Controller and boot from the internal SCSI-RAID controller. The afterwards, put the SCSI-disks back in the SCSI-Enclosure and use the CLI to configure the RAID-config. <BR /><BR />Does anyone know what to do? I've upgraded the firmware. I use a Compaq StorageWorks 4354R Enclosure.<BR /><BR />Another question, I can't get the array configuration utility (ACU) to work, thats why i have to use the CLI. Internet explorer says it can't find the page, and ask me to check that I'm connected to the internet. I've tried both local and remote. I use Windows 2006 x64 SP2.<BR /><BR />Sorry if my english is poor... Sun, 23 Sep 2007 20:34:56 GMT https://community.hpe.com/t5/disk-enclosures/smart-array-problem/m-p/4074663#M24941 altgard 2007-09-23T20:34:56Z