topic Re: EVA 4400 Management Module in Disk Enclosures

EVA 4400 Management Module

Brian U — Fri, 31 Oct 2008 21:55:26 GMT

Greetings,
I am new to the EVA 4400 (just this week). I have everything setup, however, after reconfiguring the IP address for the management module on the EVA 4400 (HSV300), and plugging it up to the LAN, I am not able to ping it from another network segment. I am able to ping it from the router however. I have double check the IP is not in use by another device, I have double checked the subnet mask and the "gateway server" as well. I am assuming the "gateway server" is the IP for the router.

Any insight on how to connect to the management interface from another IP segment would be greatly appreciated.

Thanks,
-bu

Re: EVA 4400 Management Module

Mustafa Gulercan — Sun, 02 Nov 2008 21:36:24 GMT

Hi Brian,
i couldn't exactly understand your problem.
is it like this;
" you have changed the EVA management server's IP and than you can not ping it"

right?

if it is, this problem is not about EVA.
You may talk with your network admin.

Check your new IP's VLAN from switch.
May be there is an access list which blocked you.

regards,
mustafa

Re: EVA 4400 Management Module

George Genov — Mon, 03 Nov 2008 06:49:30 GMT

Hi,

What is the IP address you are using because:

IP addresses 10.0.0.0 to 10.255.255.255 are not supported

See:
http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c01501781/c01501781.pdf

Re: EVA 4400 Management Module

Brian U — Mon, 03 Nov 2008 11:48:10 GMT

Thank you both. Yes George, I was attempting to use a class C in the 10.X.X.X range. I have no other IP segments in the entire LAN. Thank you for pointing that out. This is an interesting predicament that I hope I can find a solution for.