https://community.hpe.com/t5/disk-enclosures/failure-to-boot-proliant-1600-after-array-configuration/m-p/2593545#M2973 The following the Error Message we get while trying to boot the system after running the Array Configuration Utility: <BR /> <BR />Array Ctrl bridge BARs configured Incorrectly by System ROM unrecognized xx Controller <BR />Upgrade firmware on all Compaq Array <BR />Controllers using options ROMPAQ Thu, 11 Oct 2001 23:00:00 GMT Ayman Altounji 2001-10-11T23:00:00Z https://community.hpe.com/t5/disk-enclosures/failure-to-boot-proliant-1600-after-array-configuration/m-p/2593545#M2973 The following the Error Message we get while trying to boot the system after running the Array Configuration Utility: <BR /> <BR />Array Ctrl bridge BARs configured Incorrectly by System ROM unrecognized xx Controller <BR />Upgrade firmware on all Compaq Array <BR />Controllers using options ROMPAQ Thu, 11 Oct 2001 23:00:00 GMT https://community.hpe.com/t5/disk-enclosures/failure-to-boot-proliant-1600-after-array-configuration/m-p/2593545#M2973 Ayman Altounji 2001-10-11T23:00:00Z https://community.hpe.com/t5/disk-enclosures/failure-to-boot-proliant-1600-after-array-configuration/m-p/2593546#M2974 Please make sure that the smart array controller is on a different bus than any other PCI card. Thu, 18 Oct 2001 23:00:00 GMT https://community.hpe.com/t5/disk-enclosures/failure-to-boot-proliant-1600-after-array-configuration/m-p/2593546#M2974 Mark Cloutier 2001-10-18T23:00:00Z