topic Re: Change single controller MSA500 G2 in Disk Enclosures

Change single controller MSA500 G2

Angel Buitrago — Mon, 02 Feb 2009 15:13:06 GMT

hi,

Just to check. When i wanted to change a controller MSA500 G2 (Single), i need to power of the MSA and the servers connected to it.

Remove the damage controller and replace it with the new one. Also I need to replace the battery cache of the damage to the new.

there its something else i need to do?
Best regards.

Re: Change single controller MSA500 G2

marsh_1 — Mon, 02 Feb 2009 16:35:59 GMT

hi,

best to check through the maint manual here :-

http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/c00172836/c00172836.pdf

Re: Change single controller MSA500 G2

Angel Buitrago — Mon, 02 Feb 2009 16:36:26 GMT

ok,
i will

tks

Re: Change single controller MSA500 G2

Przemyslaw — Wed, 26 Nov 2014 14:14:49 GMT

I want to replace one of the two redundant controllers.
Can I remove it during operation of the system?
I found the description of the HP StorageWorks Modular Smart Array500 Generation 2 Storage System Maintenance and Service Guide:

to remove redundant conntroler:
1.Determine if the controller configuration supports hot-plug cache replacement:
−
If the storage system is equipped with a single controller, power down the storage system (on page9).
−
If the system has redundant controllers and the replacement cache is a different capacity than the failed cache, power down the storage system (on page9).
−
If the system has redundant controllers and the replacement cache is the same capacity as the failed cache, proceed with step 2.
2.Remove the controller ("Modular Smart Array 500 Generation 2 Controller" on page 13).
3.Remove the existing cache module.
Repeat steps 2 and 3 if the storage system has redundant controllers and the
replacement cache is a different capacity than the failed cache.
To replace the cache module:
1.Install the module in the slot....

Thanks and regards

Przemyslaw