VA7110 does not start

cbs400 — Thu, 07 Jan 2010 14:46:21 GMT

Testing internal SRAM: Passed
Activating DDR DRAM: Success
Testing L1 cache: Passed
Testing NVSRAM: Passed
DDR DRAM decode test: Passed
DDR DRAM pattern test: Passed
DDR DRAM ECC test: Passed

Copying firmware image to DRAM 38370A100P0109031436: Initializing:
02 04 06 08 0A 02 04 06 08 0A 0C 18 1A 1C 1D 1E 20 22

HP Virtual Array 7110
Firmware Image 2 selected
Activating DDR DRAM: Success
Copying firmware image to DRAM 38370A100P0109031436: Initializing:
02 04 06 08 0A 0C 18 1A 1C 1D 1E 20 22

HP Virtual Array 7110
Firmware Image 2 selected
Activating DDR DRAM: Success
Copying firmware image to DRAM 38370A100P0109031436: Initializing:
02 04 06 08 0A 0C 18 1A 1C 1D 1E 20 22

HP Virtual Array 7110
Firmware Image 2 selected
Activating DDR DRAM: Success
Copying firmware image to DRAM 38370A100P0109031436: Initializing:

and so on. The last block is repeating all the time. It is not possible to access the array from the management server.

# armdsp va7110
Array State : Pending - Starting Up
The current state of the array will not allow this command to be executed.

Re: VA7110 does not start

Robert_Jewell — Thu, 07 Jan 2010 15:11:39 GMT

The POST sequence seems to aborting after the "22" each time. This refers to the synchronizing both controller clocks.

I would recommend removing a controller to see if that helps. If not, install it back and remove the other one.

-Bob

topic Re: VA7110 does not start in Disk Enclosures

VA7110 does not start

Re: VA7110 does not start