https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004253#M40348 Can we see host HBA using Command View even witout putting Host entry manually in EVA(ofcourse the zoning is already done on the switch..) Wed, 20 Sep 2006 02:28:59 GMT sukhvinder 2006-09-20T02:28:59Z https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004253#M40348 Can we see host HBA using Command View even witout putting Host entry manually in EVA(ofcourse the zoning is already done on the switch..) Wed, 20 Sep 2006 02:28:59 GMT https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004253#M40348 sukhvinder 2006-09-20T02:28:59Z https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004254#M40349 If your management appliance is in other zone you cannot see it. It is best to put your appliance in an other zone. So you cannot see it. Wed, 20 Sep 2006 02:39:56 GMT https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004254#M40349 Luk Vandenbussche 2006-09-20T02:39:56Z https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004255#M40350 If your Host is zoned correctly to the EVA, then you will see the WWN of the HBA available in a drop-down list when you define the Host in Command View. You should not have to type it in then.<BR /><BR />Regards,<BR />Stephen Wed, 20 Sep 2006 08:04:51 GMT https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004255#M40350 Stephen Kebbell 2006-09-20T08:04:51Z https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004256#M40351 I found the answer in secon reply..its the exact explanation Thu, 21 Sep 2006 02:12:17 GMT https://community.hpe.com/t5/disk-enclosures/hp-eva/m-p/5004256#M40351 sukhvinder 2006-09-21T02:12:17Z