https://community.hpe.com/t5/disk-enclosures/msa2012fc-firmware-update-problems/m-p/5152307#M42793 I am having problems updating the firmware on an MSA2012fc. It appears that firmware update was successful on controller A, but fails to finish on controller B. I have tried cycling the power and rebooting, but keep getting the following status message:<BR /><BR />Progress, RAID Controller A:<BR /> The Partner Firmware Update feature is upgrading code from one controller board to the other.<BR /> Current State: FAILED before completion; some code components may not have been updated.<BR /> (Failed while updating the Expander Controller.)<BR />RECOMMENDED RECOVERY ACTION: Wait for other controller to finish (if running), then shut down both and cycle power.<BR /><BR />Progress, RAID Controller B:<BR /> The Partner Firmware Update feature is upgrading code from one controller board to the other.<BR /> Current State: This controller board is waiting for the other controller board to update it with newer code.<BR /><BR />Also, when I check the code versions they are the same for everything except for the Enclosure Controller Code Version. Any ideas? Fri, 23 Jan 2009 20:42:26 GMT Shane Welck 2009-01-23T20:42:26Z https://community.hpe.com/t5/disk-enclosures/msa2012fc-firmware-update-problems/m-p/5152307#M42793 I am having problems updating the firmware on an MSA2012fc. It appears that firmware update was successful on controller A, but fails to finish on controller B. I have tried cycling the power and rebooting, but keep getting the following status message:<BR /><BR />Progress, RAID Controller A:<BR /> The Partner Firmware Update feature is upgrading code from one controller board to the other.<BR /> Current State: FAILED before completion; some code components may not have been updated.<BR /> (Failed while updating the Expander Controller.)<BR />RECOMMENDED RECOVERY ACTION: Wait for other controller to finish (if running), then shut down both and cycle power.<BR /><BR />Progress, RAID Controller B:<BR /> The Partner Firmware Update feature is upgrading code from one controller board to the other.<BR /> Current State: This controller board is waiting for the other controller board to update it with newer code.<BR /><BR />Also, when I check the code versions they are the same for everything except for the Enclosure Controller Code Version. Any ideas? Fri, 23 Jan 2009 20:42:26 GMT https://community.hpe.com/t5/disk-enclosures/msa2012fc-firmware-update-problems/m-p/5152307#M42793 Shane Welck 2009-01-23T20:42:26Z https://community.hpe.com/t5/disk-enclosures/msa2012fc-firmware-update-problems/m-p/5152308#M42794 I updated the firmware directly on Controller B and all is well. Fri, 23 Jan 2009 21:44:14 GMT https://community.hpe.com/t5/disk-enclosures/msa2012fc-firmware-update-problems/m-p/5152308#M42794 Shane Welck 2009-01-23T21:44:14Z