topic Re: MSA1000 Controller indication varying disk speeds in Disk Enclosures

MSA1000 Controller indication varying disk speeds

Louann Duchemin — Mon, 24 Mar 2014 04:23:39 GMT

I have two MSA1000 controllers. On one controller, this is controller is in standby mode, the speed on the disk is 160 MB/s. On the other controller, this one is in active mode; the disk speed is 10 MB/s. There is also a notice indicating:

The speed is the currently negotiated speed to the disk. This may be less than the maximum speed supported by the device due to bus faults, loss of signal integrity, etc.

My question is how can I remove this disk from the raid set and have one of the spare take over?

P.S. This thread has been moevd from Disk to Disk Array. - Hp forum Moderator

Re: MSA1000 Controller indication varying disk speeds

Uwe Zessin — Tue, 27 Nov 2007 15:35:00 GMT

You need to pull the physical disk drive (or have somebody do it for you). As far as I can tell, SmartArray controllers do not have any means to 'fail' a disk drive by software.

Re: MSA1000 Controller indication varying disk speeds

John Kufrovich — Tue, 27 Nov 2007 15:57:56 GMT

Louann,
Uwe is correct. But you should verify that that your disk are not part of the Customer Advisory dealing with drives downshifting.

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c00677430&jumpid=reg_R1002_USEN

Re: MSA1000 Controller indication varying disk speeds

Louann Duchemin — Tue, 27 Nov 2007 16:30:27 GMT

Thank you both for your assistance. I'm having someone check on the firmware level.