https://community.hpe.com/t5/disk-enclosures/fc60-controller-in-passive-mode/m-p/2417263#M47772 OOPS!<BR />That command needs the array id after it as usual. not sure why "arrayid" <BR />surrounded by arrows as used in the users guide did not post on the first <BR />message...let me use parenthesis instead:<BR /><BR />ammgr -c AA (arrayid) Wed, 05 Jan 2000 21:33:44 GMT Nelson Broskey_2 2000-01-05T21:33:44Z https://community.hpe.com/t5/disk-enclosures/fc60-controller-in-passive-mode/m-p/2417262#M47771 In case anyone has reconfigured or otherwise confused their FC60 array (A5277A <BR />Surestore E Disk Array) such that one or both of its controllers have gone <BR />"passive" there is an undocumented (at least so far) command to reset them to <BR />"active" state. It is:<BR /><BR />ammgr -c AA <ARRAYID></ARRAYID> Wed, 05 Jan 2000 21:22:51 GMT https://community.hpe.com/t5/disk-enclosures/fc60-controller-in-passive-mode/m-p/2417262#M47771 Nelson Broskey_2 2000-01-05T21:22:51Z https://community.hpe.com/t5/disk-enclosures/fc60-controller-in-passive-mode/m-p/2417263#M47772 OOPS!<BR />That command needs the array id after it as usual. not sure why "arrayid" <BR />surrounded by arrows as used in the users guide did not post on the first <BR />message...let me use parenthesis instead:<BR /><BR />ammgr -c AA (arrayid) Wed, 05 Jan 2000 21:33:44 GMT https://community.hpe.com/t5/disk-enclosures/fc60-controller-in-passive-mode/m-p/2417263#M47772 Nelson Broskey_2 2000-01-05T21:33:44Z