topic SC10 DISK ARRAY --DIRECT CONNECT in Disk Enclosures

SC10 DISK ARRAY --DIRECT CONNECT

sameer_4 — Tue, 03 Sep 2002 14:04:21 GMT

Hi,
i have connected sc10 disk array to L class system directly using the single scsi card and sinfgle cable , i have terminated the other three connecters .But i am able to see
0/0/1/0.15.0 ctl HP A5272A

my dip switch settings are switch 1,3,4,5 are in 0 positioin and switch 2 in 1 .Plus tray id is 0 as i have only one sc10.But i am not able to see the disks ..any cluues

Re: SC10 DISK ARRAY --DIRECT CONNECT

Robert_Jewell — Tue, 03 Sep 2002 22:35:37 GMT

Well the SC10 is an LVD device and the card in the L is an Ultra2 SCSI. While these two are compatible, every device on the bus should be the same (LVD or SE). What I am not sure is what the internal drives are (LVD or SE). also take into consideration the internal SCSI ID's of these drives. If the settings on the SC10 are conflicting then there will be problems.

Unless of course you are running on its own seperate card with no other devices attached...

-bob

Re: SC10 DISK ARRAY --DIRECT CONNECT

Vincent Farrugia — Wed, 04 Sep 2002 04:31:54 GMT

Hello,

Try to put switches 3,4 and 5 to 1 as well. Also, if you want full bus mode, you have to put switch 1 to 1 as well.

HTH,
Vince

Re: SC10 DISK ARRAY --DIRECT CONNECT

Vincent Farrugia — Wed, 04 Sep 2002 04:32:52 GMT

Hello,

Try to put switches 3,4 and 5 to 1 as well. Also, if you want full bus mode, you have to put switch 1 to 1 as well.

HTH,
Vince