topic Re: Parity error/ Can't read from disk in Disk Enclosures

Parity error/ Can't read from disk

Ayman Altounji — Tue, 19 Dec 2000 00:00:00 GMT

Hi

All of a sudden my server will not boot. Hardware configuration error.

DAAD gave me the following information, What can I do ?
_____________________________________________
System ROM Version: '08/17/98'
Primary CPU: Intel Pentium Pro - 200MHz
Computer Model: ProLiant 1500

EISA ID DRIVE ARRAY CONTROLLER
---------- ----------------------
Slot 0: 0x0e110559 none
Slot 1: 0xffffffff none
Slot 2: 0xffffffff none
Slot 3: 0xffffffff none
Slot 4: 0xffffffff none
Slot 5: 0xffffffff none
Slot 6: 0xffffffff SMART-2/P
Slot 7: 0xffffffff none
Slot 8: 0xffffffff none
Slot 9: 0xffffffff none
Slot 10: 0xffffffff none
Slot 11: 0xffffffff none

Slot 6 Error Report
--------------------
RIS read status:
SCSI Port 1, Drive ID 0 RIS copy mismatch.
RIS read status:
SCSI Port 1, Drive ID 1 RIS copy mismatch.
RIS read status:
SCSI Port 1, Drive ID 2 RIS copy mismatch.
Accelerator parity read errors: 18

Re: Parity error/ Can't read from disk

Ayman Altounji — Wed, 20 Dec 2000 00:00:00 GMT

Did the Server crash , before problem started ?

Did you apply a ROMPAQ , add anything new to the Server ?

Have you tried re-running the System Configuration Utility , Array Configuration Utility ?

Have you tried upgrading the firmware on the Smart 2/P ?

Re: Parity error/ Can't read from disk

Ayman Altounji — Wed, 20 Dec 2000 00:00:01 GMT

RIS Copy Mismatch errors are a common problem with older versions of the DAAD and ADU utilities... What version are you using? Do you know what firmware the controller is using?

This type of error is usually not the cause of a boot issue. When does the configuration error come up (OS or POST)? Do you get other errors when starting the system?

Re: Parity error/ Can't read from disk

Ayman Altounji — Thu, 21 Dec 2000 00:00:00 GMT

I have used the latest patches from Compaq to analyze the problem.
At server start the array controller reports no problem. When NT loader is checking hardware its stops and displays a warning message.
"Windows NT cannot start due to hardware diskconfiguration error...."

When i use the DAAD it reports an Array controller error with a red! on the controller. I can access the partition with a DOS bootdisk and Partition Magic and even resize the partition.

The server is configured with 3x 4,3 Gb disks in RAID5.