https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477030#M729 I could use the same utility. Is there any way to configure my smart 2p controller without the SmartStartCD or Support Pack? Is there anything on the compaq site that I could download that can do this? Sun, 21 Jan 2001 00:00:00 GMT Ayman Altounji 2001-01-21T00:00:00Z https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477027#M726 I'm looking for the configuration utility for dos. I have the config utility for NT/Win2K and that is great but I'd like to make some changes and add my boot drive to the array controller and for this I would need the dos version of the utility to setup the array. Any ideas where I can find this? thx. Thu, 28 Dec 2000 00:00:00 GMT https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477027#M726 Ayman Altounji 2000-12-28T00:00:00Z https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477028#M727 You can't add an existing boot drive to an array - you WILL loose everything on it in that process. There is no current DOS version of the ACU. The last version that could run from System Configuration or be booted to was 1.20B (and that doesn't support most of the controllers we have). Fri, 29 Dec 2000 00:00:00 GMT https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477028#M727 Ayman Altounji 2000-12-29T00:00:00Z https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477029#M728 Yes I agree that I will lose all on that drive. Is their a way to get the older version of the array utility? Does that utilitiy support the smart 2/p controller? thx. Fri, 29 Dec 2000 00:00:01 GMT https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477029#M728 Ayman Altounji 2000-12-29T00:00:01Z https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477030#M729 I could use the same utility. Is there any way to configure my smart 2p controller without the SmartStartCD or Support Pack? Is there anything on the compaq site that I could download that can do this? Sun, 21 Jan 2001 00:00:00 GMT https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477030#M729 Ayman Altounji 2001-01-21T00:00:00Z https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477031#M730 The ACU (array Configuration Utility) ver 1.20 B does the trick for smart 2P array controllers. I just tried it. The softpaq number is SP6263.EXE. Sat, 10 Feb 2001 00:00:00 GMT https://community.hpe.com/t5/disk-enclosures/looking-for-array-configuration-utility/m-p/2477031#M730 Ayman Altounji 2001-02-10T00:00:00Z