Battery Failure in Smart Array 642 controller

Daren Gray — Fri, 13 Jun 2003 00:26:36 GMT

I just upgraded a Proliant ML370 G3 server's Smart Array 642 controller with a BBWC battery cache module. Everything seemed to go well(additional memory was properly recognized, etc.), but about an hour after upgrading the controller I got a notice that the battery had failed.

I'm concerned that the battery wasn't being charged...

Other than the failed battery, everything appears to be fine.

Has anyone run into this before?

Below is the system event error...

Event Type: Error
Event Source: Storage Agents
Event Category: Events
Event ID: 1067
Date: 6/12/2003
Time: 7:49:34 PM
User: N/A
Computer: xxx-xxx
Description:
Drive Array Accelerator Battery Failed. The array accelerator board attached to the array controller in slot 1 is reporting a battery failure.
[SNMP TRAP: 3027 in CPQIDA.MIB]
Data:
0000: 19 00 43 00 01 03 00 00 ..C.....
0008: 02 02 00 00 00 00 04 04 ........
0010: 01 00 00 00 01 00 00 50 .......P
0018: 35 37 38 34 30 43 44 41 57840CDA
0020: 4f 57 56 38 53 00 00 00 OWV8S...
0028: 00 00 00 00 00 00 00 00 ........
0030: 00 00 00 00 00 00 00 00 ........
0038: 00 02 00 00 00 00 00 00 ........
0040: 00 00 00 17 32 32 02 00 ....22..
0048: 00 04 00 90 02 23 00 00 ...??.#..
0050: 00 01 00 00 00 00 00 00 ........
0058: 00 00 00 00 00 00 00 00 ........
0060: 00 2b 04 35 c4 07 00 00 .+.5??...
0068: 00 01 00 ff 00 00 00 18 ...??....
0070: 64 23 00 43 00 19 00 0a d#.C....
0078: 00 ff ff 00 00 04 00 00 .????.....
0080: 00 00 00 00 00 00 00 00 ........
0088: 00 00 00 00 00 01 00 ff .......??
0090: ff ff ff ff ff 01 00 01 ??????????...
0098: 00 00 00 00 00 00 00 00 ........
00a0: 00 01 00 00 00 00 00 00 ........
00a8: 00 00 00 00 00 00 00 00 ........
00b0: 00 00 00 00 00 00 00 00 ........
00b8: 00 00 00 01 00 f0 0e 4f .....??.O
00c0: 00 00 00 ...

Re: Battery Failure in Smart Array 642 controller

Chris Choate — Tue, 24 Jun 2003 13:28:44 GMT

What version of the HP Management Agents are you running?

Do you use the Remote Insight boards? If so did you recently upgrade your firmware to the newest version?

I just started getting these message as well, but it wasn't until I upgraded my agents and firmware.

I am still researching this also.

Re: Battery Failure in Smart Array 642 controller

Terri_11 — Wed, 10 Mar 2004 11:17:54 GMT

I have just purchased a Proliant ML350. I receive the same error!! I think I'll try the new Firmware upgrade.

topic Battery Failure in Smart Array 642 controller in Disk Enclosures

Battery Failure in Smart Array 642 controller

Re: Battery Failure in Smart Array 642 controller

Re: Battery Failure in Smart Array 642 controller