topic Re: Cannot open device (Unit not ready.) after the Cell Server name has changed in StoreEver Tape Storage

Cannot open device (Unit not ready.) after the Cell Server name has changed

Koeppel, Martin — Fri, 26 Jun 2009 12:55:16 GMT

After changing the name of the Cell Server I cannot use the MSL 6060 any loger. The robotic is working fine, the tape is inserted in the drive, but the job (backup or format) ist not starting. After a while there comes "Cannot open device (Unit not ready.) and the job fails. My NetApp VTL emulating an MSL6060 is working fine.

Has somebody an idea?

Martin

Re: Cannot open device (Unit not ready.) after the Cell Server name has changed

TTr — Fri, 26 Jun 2009 13:46:03 GMT

> After changing the name of the Cell Server...
There is formal process to change the name of the cell server. Did you follow it and did you change it in all areas?Specially the device and media configuration?

Re: Cannot open device (Unit not ready.) after the Cell Server name has changed

Koeppel, Martin — Sat, 27 Jun 2009 14:22:16 GMT

Sure,
the Virtual Library is working fine. It is emulating a MSL6060. I only have problems withe physical library an drive.

Re: Cannot open device (Unit not ready.) after the Cell Server name has changed

Eblyn Solis — Mon, 29 Jun 2009 14:45:09 GMT

Hi Martin,
If you have DP omniback ,maybe you need to config again the library under the new name or change the name of the server who control the library.

Regards