topic Re: tar command in StoreEver Tape Storage

tar command

pardeep3dec — Tue, 20 Nov 2018 03:50:17 GMT

Dear experts,
I am creating tar files on tape.
#export DEV_DAT=/dev/rmt0mn
#tar cvf $DEV_DAT /tmp/p.txt
#tar cvf $DEV_DAT /tooex
#tar cvf $DEV_DAT /runex

After this
#mt - f $DEV_DAT rew

#tar tvf $DEV_DAT --showing p.txt - OK

#tar tvf $DEV_DAT --showing all the files Exists in /tooex -OK

#tar tvf $DEV_DAT -- showing tar: blocksize=0; broken pipe?
It must show files exists in /runex

Guide , why /runex files are not stored on tape.
How can i do this ?

Re: tar command

GaneshPrasad — Mon, 26 Nov 2018 16:05:44 GMT

Dear Customer,

This looks like a restriction issue with UNIX, if any file at all goes to tape and can be read back, then you might have

to consult an UNIX/Linux Admin to undertand if any restrictions are assigned,

Re: tar command

Srikanth_BK — Mon, 26 Nov 2018 17:04:53 GMT

Is this continously happening ? have you tried multiple times and same response. If it has happened only once, then it could be problem while copying, either in media or tape drive . If it has happened multiple times, then while copying, i.e., tar cvf $DEV_DAT /runex ==> did you get similar error messge.

You may also attempt 'dd' ( disk dump ), specially for db files ; man pages would give you details

I AM A HPE Employee

Re: tar command

Srikanth_BK — Fri, 30 Nov 2018 10:37:47 GMT

Kindly respond to this .

In case it has been resolved, please mention