topic Re: HPE DL360 Network Adapter not Working in Servers - General

HPE DL360 Network Adapter not Working

aelsharif — Wed, 28 Oct 2020 14:26:22 GMT

I prepare a new hpe dl360 G10 server, I installed windows server 2019 and want to connect server to the internet, Unforchantily I couldn't .. Neither The adapter wont connected to the internet or the cisco SG200-26P, it gaves me (Generic USB-EEM Network Adapter)

I'm tring to install the driver for it, I could not figure which driver for it.

Any help please

Abdulsalam

Re: HPE DL360 Network Adapter not Working

Torsten. — Wed, 28 Oct 2020 15:13:59 GMT

USB?

This sounds like the internal connection to the ILO - a virtual interface new in Gen10.

Check in ILO settings if this virtual interface is enabled and try to set up another NIC.

Re: HPE DL360 Network Adapter not Working

aelsharif — Wed, 28 Oct 2020 15:20:53 GMT

How can I check iLO setting ? Fron where ?

Re: HPE DL360 Network Adapter not Working

Torsten. — Wed, 28 Oct 2020 15:22:50 GMT

From the ILO webpage.

Connect a cable to the ILO NIC, it will get a DHCP address.

You'll find the credentials on the pullout tab in front of the server.

Re: HPE DL360 Network Adapter not Working

aelsharif — Wed, 28 Oct 2020 16:06:11 GMT

Ok .. I disabled it and now I got only two adapther:

Embedded FlexibleLOM 1 Port 1
Embedded FlexibleLOM 1 Port 2.

Where is the ethernet adapter ? Do I miss the drivers?

I check the device manager and, Please take a lock of photo .Network Adapter

Re: HPE DL360 Network Adapter not Working

Torsten. — Wed, 28 Oct 2020 16:08:10 GMT

These are your 2x 10Gbit/s Ethernet adapters.

Re: HPE DL360 Network Adapter not Working

aelsharif — Tue, 03 Nov 2020 07:34:45 GMT

@Torsten. I have only this adapter, should I install ethernet adapter to my server? There is no other ports!