https://community.hpe.com/t5/servers-general/ups-snmp-management/m-p/3966866#M4045 Set your Hyperterminal to 9600,8,1,N and then hotplug the card. Once serial port is connected, a service menu would be displayed. Use IP command to enter new IP address and NM for Netmask Mon, 26 Mar 2007 09:53:34 GMT Brian Vo 2007-03-26T09:53:34Z https://community.hpe.com/t5/servers-general/ups-snmp-management/m-p/3966865#M4044 <BR />I've got a R5500 XR UPS with an SNMP card - I'm trying to work out how to configure the card with an IP address so I can use the power manager to monitor it, etc.<BR /><BR />Any ideas how to configure this?<BR /><BR />Thanks. Thu, 22 Mar 2007 06:57:16 GMT https://community.hpe.com/t5/servers-general/ups-snmp-management/m-p/3966865#M4044 L.Scott 2007-03-22T06:57:16Z https://community.hpe.com/t5/servers-general/ups-snmp-management/m-p/3966866#M4045 Set your Hyperterminal to 9600,8,1,N and then hotplug the card. Once serial port is connected, a service menu would be displayed. Use IP command to enter new IP address and NM for Netmask Mon, 26 Mar 2007 09:53:34 GMT https://community.hpe.com/t5/servers-general/ups-snmp-management/m-p/3966866#M4045 Brian Vo 2007-03-26T09:53:34Z