topic Re: UPS Reported communication error in Servers - General

UPS Reported communication error

BCS3 — Thu, 27 Sep 2018 10:36:06 GMT

I just installed HPE Power Protector software
Connected the UPS (R1500 G3) via USB cabel
Ran a Device discovery and the UPS showed up.
After a while the sodtware (under Power source) reports "The acquisition is hanging", everythings else looks fine.
Under Event list it reports Name: 3C84330800, Message: "Reported communication error" (I does not update, there is only one message and it's from the first time it was detected)
There are no serial port on my servers, so I cannot try that.
I have tryed to switch USB cabel, with no result.
Please help, google was not my friend on this issue

BR
BCS

Re: UPS Reported communication error

BCS3 — Mon, 01 Oct 2018 05:32:53 GMT

Anyone?

Re: UPS Reported communication error

MV3 — Wed, 03 Oct 2018 03:55:09 GMT

Check if the UPS in visible in BIOS when connected to USB
Check if you are using the latest HP Power Protector.
Update the UPS firmware to latest and check for the issue.

If the issue persists, I would recommend to raise a support case with HPE.

Regards

MV3

I work for HPE

Re: UPS Reported communication error

BCS3 — Wed, 03 Oct 2018 06:36:16 GMT

I was suggested to use another version of the HPE Power Protector Software.
I was running the newest, so i tried version 1.06 vith no luck.

But version 1.05 is working with no problem..

I was already running the newest firmware.

So I guess the problem is solved by using an older version of power protector.

BCS

Re: UPS Reported communication error

AutexIT — Sun, 21 Mar 2021 20:20:39 GMT

Where can you get the older versions of this software?