topic HPUX11iv1 EVA5000 McData switch boot problem in HPE EVA Storage

HPUX11iv1 EVA5000 McData switch boot problem

Lars Christian Nilsen — Thu, 14 Jul 2005 14:44:15 GMT

Hi!

I'm having some trouble booting an rp8420 from an EVA5000 with our McData SAN switch.

Don't know a lot about SAN stuff, just want to know if anybody else has experienced problems with this configuration.

cheers,
lars c

Re: HPUX11iv1 EVA5000 McData switch boot problem

generic_1 — Thu, 14 Jul 2005 16:42:14 GMT

Was your configuration working, then quit?

If not Check that your storage is presented to the correct wwns, that you chose the correct OS on the eva, that you have links on your switch and hbas, make sure you have single initiator zones, that your server is correctly zoned in the macdata switch, that your hba drivers, and disk drivers are loaded on the OS too and up to date. Also make sure you have securepath loaded too for a EVA5000, because this EVA has an active passive controller.

Re: HPUX11iv1 EVA5000 McData switch boot problem

Duncan Edmonstone — Thu, 14 Jul 2005 23:50:21 GMT

Lars,

A bit difficult to offer advice as you only state yopu have 'some trouble'

WHat specifically are you getting in way of errors/issues.

HTH

Duncan

Re: HPUX11iv1 EVA5000 McData switch boot problem

Leif Halvarsson_2 — Fri, 15 Jul 2005 00:20:57 GMT

Hi,

- Do you use the EVA as Boot disk ?
- Is Secure Path installed ?

I have tried this, using SP 3.0E but could not get it work. Without SP installed, booting was not any problem.

So, what I found was:

Booting HP-UX11iV1 from EVA with SP 3.0D or 3.0E is supported from HP but don't work.

Booting HP-UX11iV1 from EVA without SP (single path) is not supported from HP but works.

Re: HPUX11iv1 EVA5000 McData switch boot problem

Lars Christian Nilsen — Fri, 15 Jul 2005 04:37:53 GMT

Guys! Thanks for replying quickly.

I've just discovered that my EVA is on a FW level that prevents me from booting from it. So now it's a whole new ballgame.

anyway, appreciate your views. And for record, my problem was that an Ignite recovery archive was copied over to the EVA, but it failed when I tried to boot from it.

cheers,
lars c

Re: HPUX11iv1 EVA5000 McData switch boot problem

Uwe Zessin — Fri, 15 Jul 2005 08:48:39 GMT

While you are comparing firmware revisions, its a good idea to check your RP as well I think. A few weeks ago I had an RX that didn't like a fibre channel boot and I had to update the adapter. The operating system (OpenVMS) could access the storage when I booted it from DVD, though.