topic Re: Secure Path Management CLI in HPE EVA Storage

Secure Path Management CLI

Feljav — Tue, 03 Jul 2007 14:46:41 GMT

What are the command autopath set -t use for?
-t is for timeout. What is LUN timeout value?

Re: Secure Path Management CLI

Andy_Stor — Wed, 04 Jul 2007 03:40:24 GMT

Hi this is what I found from Secure path Manual not sure if u are referring to the same command.
You can also run autopath help
autopath set device
This command sets the Load Balancing policy for the device specified by the
device number.
If no Load Balancing is set for a device, the autopath set device
command sets the Preferred path to the device.
Syntax:
autopath set device=device_number {policy=policy_name |
path=path_number}
device_number is the Auto Path index number shown in the autopath devices
command line display.
policy_name is the Load Balancing policy name.
path_number is the Preferred path number.

Andy

Re: Secure Path Management CLI

Bernd Reize — Wed, 04 Jul 2007 04:45:48 GMT

the LUN timeout value is the amount of seconds securepath waits before it markes a path as dead.
A recommended value is 60 seconds if I remember correctly.