topic Re: syslog output from HSG80 controllers in HPE EVA Storage

syslog output from HSG80 controllers

Paul Young_3 — Tue, 06 Apr 2004 21:30:37 GMT

Hello everyone,

First let me just say that I am self taught on our MA8000 and hence may ask ordinary questions. I have basically learnt my way around from the ACS command line guide and these forums.

My question relates to syslog and errors that may occur on the HSG80 that are not logged to the FMU.

Is it possible to set the HSG80 controllers up to output to a syslog server? If it is can someone let me know how.

Thanks for your time

Re: syslog output from HSG80 controllers

Uwe Zessin — Wed, 07 Apr 2004 01:50:06 GMT

Paul,
the HSG80 controllers do not have an ethernet port - they cannot speak TCP/IP. It is possible to install an agent who, if I recall correctly, can send at least mail or notify a pager (never worked with the latter). This is part of the SWCC (StorageWorks Command Console).

Last time I checked, only critical controller errors were stored in the LAST_FAILURE log of the controllers.

Re: syslog output from HSG80 controllers

Paul Young_3 — Wed, 07 Apr 2004 02:25:49 GMT

Thanks for clearing that up Uwe.

Paul

Re: syslog output from HSG80 controllers

Mike Naime — Wed, 07 Apr 2004 23:07:39 GMT

Paul:

I monitor/access both CLI ports of 36 HSG's using ConsoleWorks by TDI systems out of Texas. We monitor almost 300 serial console ports using this system. It sends us E-mails and alphapages when an event occurs. These logs are coppied to a syslog server and then saved off for long-term storage.

Note: you need an adapter cable, or you need to convert your 9 pin D to CLI cable in order to plug into your terminal server. The terminal server is setup for Telnet Listener so that it can be monitored remotely over a network.

Since we are a mainly a VMS shop, we use old DECserver 700's to plug everything into. (Even the IBM consoles!) DECserver setup is a LONG topic itself. :-)

Mike Naime

Re: syslog output from HSG80 controllers

Paul Young_3 — Wed, 07 Apr 2004 23:48:08 GMT

Thanks Mike,

I will have to look into the third party solution some more. I'll start with your suggestion.

Thanks again