topic Re: No drives visible in Netservers

No drives visible

Erik Nieuwenboom — Mon, 28 Jan 2002 09:19:50 GMT

Hi,
Can anyone provide me with a checklist of what to look for when my physical drives aren't visible anymore, I was in the middle of an Arcserve 7 Installation on a Novell 5.1 server using the E800 server, Netraid 1M and two 18gb hp scsi drives. The server went down and after restart there are no logical and no physical drives. Thanks, Erik

Re: No drives visible

Marco Hogeveen — Mon, 28 Jan 2002 12:10:39 GMT

Erik,

When you enter Netraid Express-Tools (Press Ctrl-M during POST) and you select Objects, Physical Disk. Do you see the 2 harddrives?
What's the firmware of the harddisks?
Is it HP03? then upgrade it to HP04.
See http://www.hp.com/cposupport/swindexes/hpfirmware19319_swen.html for instructions and downloads.

Marco

Re: No drives visible

Erik Nieuwenboom — Mon, 28 Jan 2002 12:16:45 GMT

Marco,

Guess I found the root of my problem:
First I did not see the hardrives, I noticed that the dat drive was also attached to scsi cable, when I removed it the logical drive was back and the physical drives where visible again under Netraid Express Tools setup. I will check the status of the firmware.

Erik

Re: No drives visible

Brian Wildman — Mon, 28 Jan 2002 20:26:41 GMT

Just an FYI for you if you didn't already know you do not want the DAT or any tape drive on a RAID controller you should run it off the embedded SCSI controller. In the e800 it has a symbios ultra 2 controller that should work fine.