https://community.hpe.com/t5/netservers/adding-ide-hdd-to-netserver-e50-w-existing-scsi-hdds/m-p/2687664#M1839 I wonder if you could install LILO on the IDE drive and have it boot the OS on the SCSI?<BR /><BR /><A href="http://octoped.net/linux/lilo-cfg.html" target="_blank">http://octoped.net/linux/lilo-cfg.html</A><BR /><BR />Ron Thu, 21 Mar 2002 03:57:35 GMT Ron Kinner 2002-03-21T03:57:35Z https://community.hpe.com/t5/netservers/adding-ide-hdd-to-netserver-e50-w-existing-scsi-hdds/m-p/2687663#M1838 I have read all the previous messages concerning adding an IDE drive to a Netserver E50 which boots from an existing SCSI HDD. I have been able to install the IDE drive and boot to the SCSI drive using a boot floppy to direct the boot correctly. My IDE drive shows up in BIOS Setup but is not accessible from OS (NT 4.0 SP6). It is listed in the SCSI Adapters Control Panel under piixide but is marked as "not unavailible (sic) because driver not loaded". Piixide is also what my CD is listed under which works fine (although it is on the secondary ide connector while the HDD is on primary). I don't know what to do next. How do I associate a driver with the device and how do I know what driver to use?<BR /><BR />BTW, if I do not use the boot floppy, the machine will boot from the IDE drive.<BR /> Thu, 21 Mar 2002 01:32:32 GMT https://community.hpe.com/t5/netservers/adding-ide-hdd-to-netserver-e50-w-existing-scsi-hdds/m-p/2687663#M1838 Kathleen Gustafson 2002-03-21T01:32:32Z https://community.hpe.com/t5/netservers/adding-ide-hdd-to-netserver-e50-w-existing-scsi-hdds/m-p/2687664#M1839 I wonder if you could install LILO on the IDE drive and have it boot the OS on the SCSI?<BR /><BR /><A href="http://octoped.net/linux/lilo-cfg.html" target="_blank">http://octoped.net/linux/lilo-cfg.html</A><BR /><BR />Ron Thu, 21 Mar 2002 03:57:35 GMT https://community.hpe.com/t5/netservers/adding-ide-hdd-to-netserver-e50-w-existing-scsi-hdds/m-p/2687664#M1839 Ron Kinner 2002-03-21T03:57:35Z