https://community.hpe.com/t5/netservers/adaptive-load-balancing-on-lpr/m-p/2801226#M3283 I have 2 NICs installed on a LPr with Windows NT /SP6a. I am using the hpset utility to configure ALB. When all settings are correct, I lose connectivity to the network. If I remove ALB and disable 1 NIC, back to normal. I have these NIC's connected to a Cisco 3548 Switch. Any suggestions to help me figure this out? Fri, 06 Sep 2002 12:07:53 GMT Melissa Helgeson_1 2002-09-06T12:07:53Z https://community.hpe.com/t5/netservers/adaptive-load-balancing-on-lpr/m-p/2801226#M3283 I have 2 NICs installed on a LPr with Windows NT /SP6a. I am using the hpset utility to configure ALB. When all settings are correct, I lose connectivity to the network. If I remove ALB and disable 1 NIC, back to normal. I have these NIC's connected to a Cisco 3548 Switch. Any suggestions to help me figure this out? Fri, 06 Sep 2002 12:07:53 GMT https://community.hpe.com/t5/netservers/adaptive-load-balancing-on-lpr/m-p/2801226#M3283 Melissa Helgeson_1 2002-09-06T12:07:53Z https://community.hpe.com/t5/netservers/adaptive-load-balancing-on-lpr/m-p/2801227#M3284 Hi!<BR />Hm, this works fine for me (not with LPr but with LP2000r connected to Cisco 3548). Did you configure something special on the 3548 ?<BR />What happens if you connect only one adapter from the alb-team to the 3548 ?<BR />What driver release do you use ?<BR />Regards, Oliver Mon, 09 Sep 2002 11:11:50 GMT https://community.hpe.com/t5/netservers/adaptive-load-balancing-on-lpr/m-p/2801227#M3284 Oliver Staehr 2002-09-09T11:11:50Z