https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832800#M3604 Thanks. My Navigator CD hangs when I launch into the Disk Array Utility. Does anybody know of an alternate way to get at the RAID config? CMD-M at startup also seems to hang... Thu, 24 Oct 2002 14:38:14 GMT Mike_245 2002-10-24T14:38:14Z https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832800#M3604 Thanks. My Navigator CD hangs when I launch into the Disk Array Utility. Does anybody know of an alternate way to get at the RAID config? CMD-M at startup also seems to hang... Thu, 24 Oct 2002 14:38:14 GMT https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832800#M3604 Mike_245 2002-10-24T14:38:14Z https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832801#M3605 try removing the HDD connected to it one at a time, see if that helps you get into CTRL-M. Thu, 24 Oct 2002 17:21:21 GMT https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832801#M3605 Theo Hill_1 2002-10-24T17:21:21Z https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832802#M3606 Thanks - I removed the first of the six drives and rebooted with a CTRL-M but it did the same thing. Comes up with...<BR /><BR />Host Adapter-0 Firmware ver..<BR />Battery Module is present..<BR />1 Logical drive found on ...<BR />1 Logical drive handled by..<BR /><BR />Then it halts with a blinking cursor... Any ideas? Thu, 24 Oct 2002 18:26:06 GMT https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832802#M3606 Mike_245 2002-10-24T18:26:06Z https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832803#M3607 That is odd, try disconnecting the cable to the backplanes and see if the same thing happens. If it does, try performing a clear cmos on the system, and then try going back in. Thu, 24 Oct 2002 20:53:31 GMT https://community.hpe.com/t5/netservers/netserver-lh-pro-and-nav-cd/m-p/2832803#M3607 Theo Hill_1 2002-10-24T20:53:31Z