https://community.hpe.com/t5/netservers/lh-2-bios/m-p/3102359#M5600 I just inherited an lh2 with a single 266 processor. I removed the single and put in two identical 300 mhz. After changing the dip switches to read the 300 it showed I only have one installed. Is there a jumper or another switch I am missing. Also I cant find the proper key combo to get into bios upon bootup. Any help would be greatly appreciated. Sun, 26 Oct 2003 01:51:26 GMT Brenden_2 2003-10-26T01:51:26Z https://community.hpe.com/t5/netservers/lh-2-bios/m-p/3102359#M5600 I just inherited an lh2 with a single 266 processor. I removed the single and put in two identical 300 mhz. After changing the dip switches to read the 300 it showed I only have one installed. Is there a jumper or another switch I am missing. Also I cant find the proper key combo to get into bios upon bootup. Any help would be greatly appreciated. Sun, 26 Oct 2003 01:51:26 GMT https://community.hpe.com/t5/netservers/lh-2-bios/m-p/3102359#M5600 Brenden_2 2003-10-26T01:51:26Z https://community.hpe.com/t5/netservers/lh-2-bios/m-p/3102360#M5601 This system does have an EISA bus and all EISA systems have a disk based setup program (ECU = EISA configuration utility).<BR /><BR />The setup program can be loaded from floppy disk, Navigator CD or can be installed on a special system partition. I think the key to load setup from system partition is F12. If the system partition is correctly installed you should get a prompt to boot from system partition during self test.<BR /><BR />You can download the ECU and other LH2 software from this page:<BR /><BR /><A href="http://h20004.www2.hp.com/soar_rnotes/bsdmatrix/matrix50452en_US.html" target="_blank">http://h20004.www2.hp.com/soar_rnotes/bsdmatrix/matrix50452en_US.html</A> Sun, 26 Oct 2003 09:02:58 GMT https://community.hpe.com/t5/netservers/lh-2-bios/m-p/3102360#M5601 Martin Breidenbach 2003-10-26T09:02:58Z