topic Re: Netserver LH4 Dead ??????? in Netservers

Netserver LH4 Dead ???????

sergio_10_1 — Sat, 27 Dec 2003 03:11:05 GMT

Hello sorry for my I englais use a translator Here did my problem I possede a netservor lh4 and veil that this morning I power on it and then ya just the fan who demmare the screen lcd functions my I nes no image has the screen of the monitor I nes not of signal coming from the mother board y' has to you it a means of knowing if these my mother board or my CPU which dead???? Thank you

Re: Netserver LH4 Dead ???????

Terri Harris — Mon, 29 Dec 2003 09:23:55 GMT

1. Remove all memory (all RAM)
2. Power up. Does the server beep? If no beep, the system board is probably dead.
3. Put the memory back in.

Try disconnecting everything:

- floppy drive
- CD-ROM drive
- remove all hard drives
- remove any extra memory
- remove all PCI cards

Clear CMOS:

. To clear the CMOS configuration.
a. Turn the server off and unplug it. Take the case off.
b. Locate the set of system switches on the motherboard.
c. Move Switch # 5 to the opposite position.
d. Power up the server. You will see a configuration error. The server will stop at this error.
e. Turn the server off, unplug it. Move Switch #5 back to the original position.
f. Power up the server. The BIOS program must be run to reconfigure the server:

F2 during POST
F9 to reset to factory defaults
F10 to save & exit

Try clearing CMOS several times.
Reseat everything - CPUs, VRMs, processor board, System Board.

Good luck!

Re: Netserver LH4 Dead ???????

sergio_10_1 — Mon, 29 Dec 2003 15:26:38 GMT

hello

Thank you for your information,my that does not have to function in my case.
If my vrm of CPU is dead its could remove the beep beep system? after makehaving made research I believe that my problem is to explain has this page my it speaks about multi CPU me I have just one

my have Delta VRM 8.3

At power on, BIOS messages and other text will not appear, the screen will be blank
The CD-ROM LED blinks
VXI VRM
Delta VRM

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=thp00588

Thank you

Re: Netserver LH4 Dead ???????

Terri Harris — Mon, 29 Dec 2003 15:31:45 GMT

Since the VRMs are cheap, I would try replacing.

But if you remove all RAM and no beeps -> bad!

Re: Netserver LH4 Dead ???????

sergio_10_1 — Mon, 29 Dec 2003 16:53:38 GMT

Thanks Terri Harris